malletKAT User Manual (ver.07-17-18)
OTHER EDITING TIPS:
Several settings can be changed during one time of depressing the EDIT Footswitch
All changes you make to your Setups are saved immediately when you change them. You do not need to do any
specific action to “save” your changes – it happens automatically.
To recover from unwanted changes, simply hit “Cancel” (A# on the highest octave). Changes that you have made
to a Setup may be undone as long as you have not gone away from this Setup to another one.
You are able to copy the current Setup to any other Setup using the “Setup Copy” pad. To do this, perform the
following steps
1. Hit the “Setup Copy” pad (G# on the highest octave) while the Edit is pressed.
2. Enter the digits of the Setup number to which you would like to copy the current setup.
3. Hit the “Setup Copy” pad again to see the con rmation screen.
4. Hit the “Setup Copy” pad a third time to perform the copy. After the copy is performed, the Setup that you
copied to is the current Setup.
4.1.1. malletKAT EXPRESS - Accessing Editing Functions
All of the malletKATs, regardless of size, contain the same functions.
Because the Express does not have the third octave required to access editing the same way that the Pro and
Grand can, we need to “trick” the Express in order to get at these functions.
On the Express, the label that shows the edit definitions for this octave appear ABOVE the pads, instead of
below. When you step on the
Edit Footswitch AND the Sustain One Footswitch at the same time, the
23 / 109
To Next Page
Loading...
