malletKAT User Manual (ver.07-17-18)
POLYPHONY COUNT
Short Cut = # 08
Parameters = 1 Note, 2 Note
The malletKAT Pro may be set to 1 note polyphony or 2 note polyphony. If one note polyphony is selected, a note
currently sounding will be turned off by the malletKAT PRO before the same note is played again. If two note
polyphony is selected, two notes of the same pitch will be allowed to sound at the same time before a third note of
the same pitch causes one of them to be turned off by the malletKAT.
One note polyphony is different than monophonic in that only one sound of any pitch plays at one time. If notes
get stuck on in two note polyphony Mode, then your sound module is not compatible with this feature. You will
then need to set this parameter to one note polyphony.
The following Kit Auxiliary Screens are described in the Note Reassignment(https://alternatemode.com/online-
docs/malletkat/#note-reassignments)
Section
REASSIGNMENT MODE
REASSIGNMENT POLYPHONY SETTING
REASSIGNMENT NUMBER
REASSIGNMENT OCTAVE OFFSET
REASSIGNMENT FORCED GATE
REASSIGNMENT TRANSPOSE AMT
REASSIGNMENT EXTRA PROGRAM /VOLUME SENDS
REASSIGNMENT POLYPHONY and INTERFACE
SLEW DATA STRIP RATE
The following Kit Auxiliary Screens are described in the Setting Up the Pedal
Inputs(https://alternatemode.com/online-docs/malletkat/#setting-up-the-pedal-inputs)
section
SUSTAIN FTSW 1 SUSTAINS
SUSTAIN FTSW 2 SUSTAINS
WARP MODE is describe in its own section: Using Warp Mode(https://alternatemode.com/online-
docs/malletkat/#using-warp-mode)
7.4. MIDI IN and MIDI Routing
The malletKAT has some advanced MIDI capabilities that require some additional configuration.
Consider the following real life scenarios:
1) You want to use the malletKAT with both the internal sound card and external MIDI sources – either
simultaneously or independently – without MIDI “crosstalk”
2) You want an outside source like a computer/DAW, tablet, or drum pad controller to use the malletKAT internal
sound card through the MIDI IN port.
98 / 109
To Next Page
Loading...
