malletKAT User Manual (ver.07-17-18)
Global Auxiliary Shortcut #69
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
RTC CONTROLLER#
Parameters = 00-128
This is where you assign the controller number. Choices are NO, 0-128. Number 128 is a Pitch wheel assignment.
The last line on the display will show the name of the controller number assigned. For more information of MIDI
Controller numbers, refer to the section MIDI Continuous Control Number (CC)
Definitions(https://alternatemode.com/online-docs/malletkat/#midi-continuous-control-number-cc-definitions)
Global Auxiliary Shortcut #70-72
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
RTC MIN VALUE
RTC MAX VALUE
RTC RESET VALUE
The Global Edit Screens (70,71, and 72) is where you assign the MIN VALUE, MAXIMUM VALUE and RESET
values.
Setting the Min and Max values gives the range of the “white key” pads on the malletKAT. Since there are 127
controller values available, and only 21 “white pads” on a three octave instrument, the malletKAT averages the
total value of the assigned range over these pads. The min and max settings affect the total range of controller
values that are averaged across the white pads. The RESET value is the controller value sent when the RESET
PAD is struck or when Exiting and Entering a new controller pad (see below).
Notice that the top line of the display is not editable. It is for your reference to remind you of what black key you
are working on.
Global Auxiliary Shortcut #73,74
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
RTC PREV CNTRL VALUE
RTC NEXT CNTRL VALUE
Parameters = Reset, None, Last
67 / 109
To Next Page
Loading...
