malletKAT User Manual (ver.07-17-18)
THRESHOLD ADJUST
The Threshold of each individual pad may be adjusted at this screen by hitting the pad you wish to alter. When
the pad has been selected, you may increase or decrease the threshold using the BACKWARD / FORWARD
(F1&F2) pads. The lower the threshold, the more sensitive the pad ( & more likely to false trigger). For more
information, refer to the section Adjusting Pad Thresholds(https://alternatemode.com/online-
docs/malletkat/#adjusting-pad-thresholds)
The following Global Screens are described in the Training Your malletKAT To Your Playing
Style(https://alternatemode.com/online-docs/malletkat/#training-your-malletkat-to-your-playing-style)
Section
TO TRAIN PADS
TO TRAIN PAD GROUPS
TO TRAIN INDIVIDUAL PAD [A…..N]
TRAINING RESULTS
Global Auxiliary Shortcut #08,09
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
TRAIN FOOT CONTROLLER ONE / FOOT CONTROLLER TWO
The response of FootController (1,2) may be set at this screen by training the FootController. If you would like to
Train the FootController, strike any pad one more time and release the Edit Footswitch. The malletKAT will sound
a continuous beep. You should respond by pressing the FootController pedal to the floor and then hit a pad. The
malletKAT will again sound a continuous beep. You should now release the FootControl pedal and hit a pad
again. The FootController is now trained and the malletKAT will return to PLAY Mode. Foot Controllers are fully
described in the Using the Foot Controller Inputs(https://alternatemode.com/online-docs/malletkat/#using-the-foot-
controller-inputs)
Section
Global Auxiliary Shortcut #42,66
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
TUNE INSTRUMENT
Parameters = -50+50 cents, MIDI CHANNEL 1-16
If your external sound source responds to the TUNING Command or if you have an older malletKAT with sounds,
you can globally detune your sound module in “cents”.
92 / 109
To Next Page
Loading...
