EasyManua.ls Logo

Alternate Mode malletKAT - Page 95

Alternate Mode malletKAT
109 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
malletKAT User Manual (ver.07-17-18)
numbers 0-127. For this reason, it might be necessary to adjust your Bank (and Program Change) settings by one
number.
BREATH CONTROLLER ASSIGNMENT
Short Cut = # 19
Parameters = CC# 00-128 (including some individually named CC Functions)
This function routes the incoming Breath Control data to the speci ed Continuous Controller function.
BREATH CONTROLLER CHANNEL
Short Cut = # 23
Parameters = Same as CNTRL1, Same as CNTRL2, Both Controllers, 01-16.
Assigns the incoming Breath Control data to MIDI channels 1-16, the MIDI channel assigned to Controller 1 or 2
or Both.
BREATH CONTROLLER CURVE
Short Cut = # 22
Parameters = 00-11
This parameter controls the response of the breath controller by assigning a curved response to the incoming
breath input. (linear, exponential, etc)
BREATH CONTROLLER MAXIMUM EFFECT
Short Cut = # 21
Parameters = 00-127
This parameter establishes the maximum controller effect from the incoming breath control data.
BREATH MINIMUM EFFECT
Short Cut = # 20
Parameters = 00-127
Established the minimum controller effect from the incoming breath control data.
The following editing screens are described in the section Using the Foot Controller
Inputs(https://alternatemode.com/online-docs/malletkat/#using-the-foot-controller-inputs)
FOOT CONTROLLER ONE ASSIGNMENT
FOOT CONTROLLER ONE CHANNEL
FOOT CONTROLLER ONE CURVE
FOOT CONTROLLER ONE MAXIMUM EFFECT
FOOT CONTROLLER ONE MINIMUM EFFECT
FOOT CONTROLLER TWO ASSIGNMENT
FOOT CONROLLER TWO CHANNEL
FOOT CONTROLLER TWO CURVE
FOOT CONTROLLER TWO MINIMUM EFFECT
FOOT CONTROLLER TWO MAXIMUM EFFECT
INTERFACE MODE
Short Cut = # 25
Parameters = Both, Internal and External, Neither, External MIDI only, Internal MIDI Only. Controller One and Two
can be configured to route their data specifically to an internal sound card, an external source, both, or neither.
From firmware version 7.5B and later, this also affects which MIDI OUT port (rear or side) will have MIDI data
present. Please refer to the section, MIDI IN and MIDI Routing(https://alternatemode.com/online-
95 / 109

Table of Contents

Other manuals for Alternate Mode malletKAT

Related product manuals