Amazone AMACO - E N T E R I N G M a C H I N E F a C T O R a N D W O R K I N G W I D T; F a C T O R F O R D I F F E R E N T M a C H I N E

Commissioning
22
Amaco BAG0028.0 04.06
6.2 Entering machine factor and working width
6.2.1 Factor for different machines
Machine Drive Factor
AD-P Special star wheel 113.5
AD-P Super star wheel 101.4
AD03 Star wheel w/ sprocket wheel 26 399.2
AD03
Variant
Star wheel w/ sprocket wheel 26 259.5
AD03 Tyre packer roller RP 238.3
C-Drill star wheel 306,5
Machine Tyres Factor
D9 6.00 – 16 216.3
D9 10.0 / 75-15 225.0
D9 31x15,5-15 231.4
C-Drill
6.2.2 Calculating the factor
If you conduct a calibration test with another number of wheel turns
than shown in the tables (on page 19) or when the sensor for the
magnet is fitted to your seed drill in another way than shown in para.
5, calculate the data of your seed drill and programme these data as
follows:
1. Drive with your seed drill a calibration distance ( L ) of at least
100 m.
2. Hereby count the number of turns ( z ) of the magnet on the gear-
box shaft.
3. Calculate the factor from the values determined:
L (m) x 100
factor =
z
Example: L = 100 m
z = 59.5
100 (m) x 100
factor =
59.5
factor =
168.1