Commissioning
18
Amaco BAG0028.0 04.06
6 Commissioning
After the seed drill has been attached to the tractor, plug the plug of
the sensor into the calculator socket and tighten securing nut.
Switching on computer
Press
- key or - key.
→
Display (briefly):
Number of calculator version e.g. “HA. X.X”
→
Automatic checking the battery voltage.
If voltage too low: display : [-bl-].
→
Display:
The latest programmed implement-No., e.g.
F.4
If the display shows [-bl-] switch off calculator (see on page 24)
and exchange batteries (see on page 15).
For the AMACO to correctly measure the worked area, the following
must be entered according to the machine:
•
a factor and the working width
or
•
a code
Entering machine code (see on page 19)
•
Inform the calculator of the description of the seed drill by enter-
ing the code (e. g.
F.13
). The code indicates to the calculator the
required information regarding the working wi dth of the seed dr ill
and the relation between the number of magnet turns to the
travelling distance.
Entering machine factor and working width (see on page 22)
•
Note the number of crank turns at the wheel next to the code in
the tables. If you conduct a calibration test with another number
of wheel turns than show n in the tables or w hen the sensor for
the magnet is fitted to your seed drill in another way than shown
in para. 5, calculate the data of your seed drill and programme
these data as follows:
•
For
AMAZONE D9
,
AD-P
,
AD03
.
To Next Page
Loading...