Commissioning
Amaco BAG0028.0 04.06
23
6.2.3 Programming (entering) factor and working width
Programme the factor determined and the working wi dth of your seed
drill as follows:
1. Press
- key for 2 seconds. Display: flicking code number
2. Press
-key un til the cod e number ”F.0” (flicking) appears.
3. Press
-key until the sy mbol [ o ] appears Display: The fac-
tor of the code ”F.0”, which you may change as follows:
3.1 Press
-key u n til the comma is in the right place.
3.2
Display: 1st figure flicks
3.3 Press
-key , until 1st figure is correct..
3.4 Press
-key. Display: 2nd figure flicks
3.5 Press
-key until 2
nd
figure is correct
.
Continue th is wa y unti l the factor (e.g.
[168.1])
is set.
4. Press
-key u n til symbo l [ I- - - -I ] appears. Display: Work-
ing width of the coding ”
F.0
”, which yo u may change as follows.
4.1 Press
-key u n til the 1st fig u re flicks.
4.2 Press
-key u n til the 1st fig u re is correct..
4.3 Press
-key. D isplay: 2nd figure flicks.
4.4 Press
-key until 2nd figure is correct.
Continue this wa y until the w o rking width (e.g.
[_3.00]
for 3 m
working width) has been set.
5. Press
-key un til the imple m ent-No. ”
F.0
” appears.
The factor which you have programmed and the programmed working
width have been stored under the code ”
F 0
”.
To Next Page
Loading...