To Next Page

To Previous Page

Start-up

AMADRILL+ BAH0040-9 01.19

2. Insert the power cable (Fig. 19/1) into the

bracket and the 12V tractor socket.

3. Connect the bracket and the control

terminal with the power cable (Fig. 19/2).

4. Couple the seed drill or soil tillage

implement to the tractor vehicle (see

operating manual for seed drill or soil tillage

implement).

5. Route the implement cable into the tractor

cab and plug the implement plug (Fig. 19/3)

into the terminal.

Fig. 19

The implement plug is secured against

unintentional release by means of a

spring-loaded lever.

Actuate the lever before releasing the

implement plug.

5.3 Switching the control terminal on/off

Switch the control terminal on and off by pressing the button.

Enter the implement-specific data (see section "Settings", Seite 26). When the control terminal is

switched back on, the data is available again.

Before using a seed drill of a different type, enter the implement-specific data on the control terminal.

When switching on the control terminal, the software version of the control terminal briefly appears.

If the supply voltage, e.g. when starting the tractor, drops below 10 volts, the control terminal is

switched off.

Amazone AmaDrill+ User Manual

Questions and Answers: