Amazone AmaDrill+ - Settings; Enter Implement Data

Settings
26
AMADRILL+ BAH0040-9 01.19
6 Settings
6.1 Enter implement data
The control terminal requires input of the implement data in coded form (see Fig. 20).
Refer to the machine data in the table (see section "Machine data table", Seite 54).
Press the
button repeatedly to display the inventory data.
Digit 1 (1) shows the mode
Digit 2 (2) shows the coding
Fig. 20
Open the necessary modes (1, 2, 3, etc.) and enter the machine data in coded form:
1. Press buttons
and .
2. Press the
button repeatedly until the desired mode is displayed (Fig. 20/1).
3. Press the
or button.
 Set the code (see section "Machine data table", Seite 54).
4. Press
.
 Confirm the set value.
5. Press
.
 Exit the menu.