Amazone AmaDrill+ - Page 34

Settings
34
AMADRILL+ BAH0040-9 01.19
12. Press
.
The gearbox setting value on the control terminal must be the same
as the scale value indicated by the gearbox setting lever.
13. Press the
and buttons simultaneously.
14. Start with the crank turns for the calibration test.
15. Stop the cranks when you hear an acoustic signal, then press the
button.
In its calculations, the AmaDrill+ takes account of the additional rotations after the acoustic
signal.
16. Weigh the collected seed quantity.
17. Press the
or button.
 Enter the weight [kg] of the collected seed quantity on the control terminal.
18. Press
.
 Save the value.
 The AmaDrill+ calculates the required gearbox setting based on the data from the calibration test
and displays the required scale value on the control terminal.
19. Set the gearbox setting lever (Fig. 29/1) to the scale value and fasten with the knurled screw (Fig.
29/2).
20. Repeat the calibration test and check whether the desired spread rate (kg/ha) is achieved.