Settings
36
AMADRILL+ BAH0040-9 01.19
9. Start with the crank turns for the calibration test.
10. Stop the cranks when you hear an acoustic signal, then press the
button.
In its calculations, the AmaDrill+ takes account of the additional rotations after the acoustic
signal.
11. Weigh the collected seed quantity.
12. Press the
or button.
Enter the weight [kg] of the collected seed quantity.
13. Press
.
Save the value.
The AmaDrill+ calculates the required gearbox setting based on the data from the calibration
test. The pointer (Fig. 30/2) moves to the calculated scale value.
14. Repeat the calibration test with the last gear setting to verify it is correct.
To Next Page
Loading...
