Installation and Start Up
| 3-1
INSTALLATION AND START-UP
Prior to Installation
Installation drawings found in this section are for typical instal-
lations. Any customer drawings (CDs) supplied with the system
supersede the drawings included here.
The installation of the analyzer must be in accordance with all of the
customer (end user) and local regulatory standards and procedures.
There are no operator-serviceable components inside the analyzer.
Refer service requirements to qualified personnel.
Read this entire section before beginning installation of the Model 888
Analyzer. Failure to do so, and / or use of the analyzer in a manner
not specified in this manual, may impair the protection against fire,
electrical shock and personal injury originally provided by this equip-
ment.
Personnel Technical Level Required for Installation
Installation must be performed by qualified persons in accordance with
local codes and NEC and CEC codes, where applicable. Prior to installa-
tion please consult the local codes in order to understand what is accept-
able. To the extent this information is not consistent with local codes, the
local codes should be followed. It is recommended that only trained personnel
perform these installation steps.
!
CAUTION
!
WARNING
!
WARNING
To Next Page
Loading...
Need help?
General
