To Next Page

To Previous Page

Parts Replacement

| 7-1

PARTS REPLACEMENT

Do not open the enclosure door unless the area is known to be free of

hazardous gases. Units with purge controllers need to be programmed

for Bypass to power the electronics.

There are hazardous voltages inside the electronics enclosure. Only a

qualified technician should work on the analyzer while it is powered

up.

There are hot surfaces present in the oven enclosure. Allow the oven

to cool to ambient temperature before touching components with bare

hands. Protective Equipment (high temperature gloves) can be used.

Hazardous gas is present in the sample system. This applies to the

oven enclosure only as there is no sample gas present in the electron-

ics enclosure. H

S and SO

are present in the process gas. Gas moni-

tors and protective equipment should always be used when working

with the sample system.

Take precautions against electrostatic discharge when handling all

circuit assemblies in the electronics enclosure. Use a grounded wrist

strap and anti-static work surfaces.

CAUTION

Ametek 888 User Manual

Questions and Answers: