Contents | 9
The glass Xenon Flash Lamp is under high internal pressure which
could result in flying glass fragments if ruptured. Handle the tube
with care to avoid dropping it, subjecting it to impacts, applying
excessive force to it, or scratching it.
While handling a flash lamp, always wear protective devices (face
mask, clothing) to prevent possible injury, especially to hand and face
areas.
Before working on the sample system, confirm that the system has
been purged with zero fluid and is isolated (blocked in) from the pro-
cess.
The analyzer oven enclosure and components inside the analyzer oven
are hot; always wear protective devices to avoid burning yourself.
Check the sample probe installation, sample connections at analyzer,
and sample return for leaks before opening sample inlet ball valve and
sample return valve.
The sample gas contains highly toxic and corrosive substances.
Proper personal protective equipment including fresh air breathing
apparatus, eye protection, and skin protection MUST BE worn when
installing the sample tap and/or opening the main oven chamber for
inspection or maintenance.
The sample gas contains highly toxic and corrosive substances. Ana-
lyzed sample must be returned to the process or vented to a safe area.
THIS ENCLOSURE IS PROTECTED BY PURGING
Enclosure shall not be opened unless the area is known to be non-
hazardous, or unless all devices within have been de-energized. Power
shall not be restored after enclosure has been opened until the enclo-
sure has been purged in accordance with the purge system start-up
instructions.
ATTENTION
Humidity may damage the installed Optical Filters. Any such dam-
age is not covered by Ametek’s warranty. Please consult Ametek or
your local Ametek represenitive for further advise.
!
!
!
WARNING
!
WARNING
!
!
WARNING
To Next Page
Loading...
Need help?
General
