Ametek Sorensen SG Series - 2.4 Readback Functions; 2.5 Specifications

IEEE/GPIB Features, Functions, Specifications SG Series Programming
2-2 M550129-03 Rev L
2.4 READBACK FUNCTIONS
 Actual measured voltage and current
 Voltage and current settings
 Soft voltage and current limits
 Overvoltage protection setting
 Status and Accumulated Status registers
 Programming error codes
 Fault codes
 Manufacturer, power supply model, and firmware version identification
2.5 SPECIFICATIONS
Specifications are subject to change without notice. Refer to your SGA/SGe
or SGI power supply operation manual for effects of line regulation, load
regulation, and temperature on accuracy specifications.
2.5.1 Programming Resolution
Voltage: 0.002% of full scale (SGe 0.01% of full scale)
Current: 0.002% of full scale (SGe 0.01% of full scale)
Overvoltage Protection: 0.002% of full scale (SGe 0.01% of full scale)
(full scale is 110% of max output voltage.)
2.5.2 Programming Accuracy
Voltage: ± ( 0.1% of maximum output voltage)
Current: ± ( 0.4% of maximum output current)*
Overvoltage Protection: ± (1.0% of max output voltage) (SGe 3.0% of max
output voltage)
* After 30 minutes operation with fixed line, load, and temperature.
2.5.3 Readback Resolution
Voltage: ± 0.002% of full scale (SGe 0.01% of full scale)
Current: ± 0.002% of full scale (SGe 0.01% of full scale)
2.5.4 Readback Accuracy
Voltage: ± ( 0.15% of full scale output voltage) (SGe 0.2% of full scale)
Current: ± ( 0.4% of full scale output current)*
* After 30 minutes operation with fixed line, load, and temperature.