Ametek Sorensen SG Series - 4.2.3 Readback Functions; 4.3 Specifications; 4.3.1 Ethernet;LAN Configuration; 4.3.2 Ethernet Configuration Factory Defaults

SG Series Programming Ethernet Features, Functions and Specifications
M550129-03 Rev L 4-3
 Soft limits for voltage and current
 Overvoltage protection
 Output enable/disable
 Maskable fault interrupt
 Hold and trigger
 External relay control
 Full calibration
4.2.3 Readback Functions
 Measured voltage and current
 Voltage and current settings
 Soft voltage and current limits
 Overvoltage protection setting
 Status and Accumulated Status registers
 Programming error codes
 Fault codes
 Manufacturer, power supply model, and firmware version identification
4.3 SPECIFICATIONS
(SUBJECT TO CHANGE WITHOUT NOTICE)
4.3.1 Ethernet/LAN Configuration
 Ethernet Standard: IEEE-802.3 compliant
 Technology: 10/100Base-T
 Connection Monitoring: Media Sense supported
 Protocol: TCP/IP, IPV4
 ICMP (ping server): Enable (default)/Disable
 IP Address Assignment: Automatic via DHCP (Primary default), Static,
or Automatic Private IP Addressing (Auto-IP, Secondary default)
 VXI-11 Discovery: Supported
 Security: Password protected access, and selective permissions for
each user
4.3.2 Ethernet Configuration Factory Defaults
PARAMETER
DEFAULT
Host Name
SGx<base model>-<last four digits of serial number>