3-2 | Thermox Series 2000 WDG-IV / IVC / IVCM
This chapter shows you how to install your Series 2000 controller and
WDG-IV sensor components, and includes the following sections:
• Inspection of Shipping Contents
• Mechanical Installation
• Wiring
• Series 2000 Control Unit Option Card Installation
If you have an oxygen-only analyzer without the combustibles option, the
combustibles and methane options described in this chapter do not apply.
These combustibles and methane sections are clearly identified. Likewise,
if you have the combustibles option, but not the methane option (3-in-1
analyzer), you can skip all sections pertaining to methane.
Inspect Shipping Contents
Remove any packing material from the sensor and the Series 2000 control
unit. Check for damage. If any is found, notify the shipper.
To Next Page
Loading...
Need help?
General
