4-2 | Thermox Series 2000 WDG-IV / IVC / IVCM
Control Unit Keys
Each of the Control Unit keys provides a menu of choices.
Key Function
Setup Set up the control unit for your specic application.
Calibrate Set calibration parameters and start calibrations.
Analog Range Dene parameters that control analog current outputs.
Alarm Dene parameters that control the alarm relays.
Help Access control unit on-line help.
Cancel Cancels out of menu options.
Enter Conrm menu choices and values.
Selecting Menu Options
Select a menu option, by pressing the Down arrow key until the arrows are
pointing at the menu option, then press Enter. The selected choice has an
asterisk (*) in front of it.
For example, if you select the Display option from the Setup key, and then select
“Display Line 1”, the current choice on display line 1 will have an asterisk in front
of it (for example, % oxygen).
If all menu options are not able to be listed on the display, there will be a
Down arrow on the far right of the last line of the display. This indicates that
there are more menu options to view. When the Down arrow disappears,
there are no more menu options to display. Conversely, if an Up arrow ap-
pears on the far right of the first line of the display, there are more menu
options available if you press the Up arrow key.
Exiting Menu Options
To exit a menu, press Cancel. To exit out of all menus, continue to press
Cancel until all menus disappear from the display and only process read-
ings remain.
Pressing the Cancel key does not delete any settings you have set
while in that menu.
To Next Page
Loading...
Need help?
General
