Ametek Thermox Series 2000 WDG-IVC User Manual

4-4 | Thermox Series 2000 WDG-IV / IVC / IVCM
Setup Key
Display Passwords
System Serial #
Primary Calib
Communication
Process Pressure
System Tests
Sensor COnfig
Combustibles
SETUP KEY
Figure 4-2. Setup Key menu options.
SETUP KEY
Menu Options
Functions/Options
Display Dene what information to place on each display line.
Passwords Create a system password to limit control unit access.
Process
Pressure
Select a positive or negative process pressure.
Enter process pressure value.
System Tests Perform internal diagnostics on Series 2000.
System Serial # View serial and manufacturing number for the control unit.
Primary
Calib
Perform an automatic, remote, or manual primary calibration
This is not a typical calibration. A primary calibration is intended to extend the life
of your sensor. Do not perform this type of calibration unless specically instruct-
ed to do so.
Sensor Cong Select the type of sensor you are using.
Communication Dene Series 2000 communication parameters.
Combustibles Dene combustibles scale (% or PPM).
Dene combustible detector type.
This only applies if you purchased a combustibles detector.

Ametek Thermox Series 2000 WDG-IVC Specifications

General

Brand	Ametek
Model	Thermox Series 2000 WDG-IVC
Category	Measuring Instruments
Language	English