Page 18
EWCIE Technical Manual
5.9 System Messages
The EWCIE amplifier/tone-generator shall have standard system messages programmed by default.
They cannot be overwritten. These messages are shown in the table below.
Message Length Description
Evacuation “Emergency – Evacuate Now” (for AS1670.1 and NZS4512)
Alert 6s
“An incident has been detected in the building – please prepare to evacuate
and wait further instructions” (for AS1670.1 and NZS4512)
False Alarm 8s
“May I have your attention please – A false alarm has been detected. The
all clear is now given. Thank you for your patience and understand”
System Test 4s “This is a fire alarm test”
Lockdown 3s No Message (tone only)
5.10 Custom Messages
The EWCIE can have custom messages programmed. For details on how to program and use custom
messages refer to section 9 and 10 of the OWS Programming Manual MAN3084.
To Next Page
Loading...
