Page 28
EWCIE Technical Manual
10 Standalone Panels
The EWCIE is available as a fully contained, battery backed standalone panel.
The standalone panel consists of a Front Panel Switch and Indicator module, a PSU an optional Zone
Indication Module and can accommodate a combination of 25W Amplifiers, 50W Amplifiers and Line
Monitoring Units to suit single or multiple zone installations.
10.1 The Cabinet
Features:
The cabinet is capable of being either surface or flush mounted. When flush mounted a
separate surround is required.
Normally painted Surfmist. Other colours are available on request.
The inner and outer door hinges are mounted on the left-hand side of the cabinet which allow
the doors open to an angle of 100º.
Outer door is locked using the standard 003 key.
Knockouts are positioned at the top and rear of the cabinet to simplify cable entry. The larger
range of cabinets use a removable gland plate to allow for the greater amount of cabling
10.2 Mounting the Cabinet
Note: It is recommended the cabinet should be installed in a clean, dry, vibration-free area.
Open the front door. Use the keyhole mounting holes in the top corners and in the lower middle of the
unit to mount it on the wall. Cables to connect the system to its external actuating devices are brought
in through the knockouts on the top or bottom of the cabinet.
Tap lightly around the
rim of the knockout
R 6mm.
12 mm
3 mm
Figure 10: Example SP1X Back Pan Mounting Hole & Removing Knockouts
To Next Page
Loading...
