Ampac LoopSense User Manual

Page 43
LOOPSENSE EN54 USER MANUAL
7.7 Event Logging
Events are logged into one of eight event type categories. Individual storage is pre-allocated for each
event type amounting to a total of 1000 events:
Event Type Maximum Capacity
Fire 100
Fault 200
Disable 100
Pre-Alarm 100
Emergency 100
Security 100
User 100
System 200
If an event exceeds the maximum capacity for that type the oldest event will be discarded allowing
the most recent event to be stored.
Events that are logged may contain the following attributes:
 Event Type
 Event Status
 Date/Time of occurrence
 Event Origin
 Active Password ID (stored with event origin)
 Checksum
The system event log contains system input action type events as well as the following system
events:
 Loop Test with password ID
 Walk Test with password ID
 Lamp Test with password ID
 Override key press with password ID
 Silence/Resound key press with password ID
 Reset key press with password ID
 Evacuate key press with password ID
 Access Level change with password ID
The fault event log contains input action type fault events as well as all reported faults within the
FACP. The disable event log contains all reported system disables. All other event types are only
logged according to their assigned input action type events.
Note: The Transparent action type is not logged.
The events are viewed by individual type or collectively. The events can be printed or erased by
individual entry, range by date/time, range by entry number, and all by entry number. Each event
type can also be disabled or enabled.
All events can be uploaded using the PC configuration software which will format the event record to
be viewable using Microsoft Excel or a standard text editor.

Ampac LoopSense Specifications

General

Brand	Ampac
Model	LoopSense
Category	Control Panel
Language	English