Maintenance and care
38 Edition 03.19 qTOWER
3
/ qTOWER
3
G
20. Use [CLOSE] to close the window.
The inserted color modules are ready for measurements.
Define a new color module as follows:
Click [A
DD] on the left of the window.
A new color module with the name COLOR.000.000.00.0 is created.
Enter the name, position and properties of the color module on the right-hand
side of the menu window.
Remove a color module as follows:
Select the color module from the C
OLOR MODULES list. Click on [DELETE].
The properties of a color module can be changed as follows:
1. Activate the P
ROPERTIES checkbox.
2. In the P
OSITION list, select the position of the color module on the carrier in the
fluorescence measuring head.
3. Enter the code of the color module into the C
ODE OF MODULE field.
4. Enter the dye to be detected with the color module into the D
YES field. Click on [+].
The dye is added to the list.
To remove a dye, select it in the list and click on [-].
5. Click
[ACCEPT] to assign the properties to the marked color module.
To Next Page
Loading...
