Wizard 411 iii
Readout Parameter Access Code
An access code must be entered before machine-related installation parameters can be set
or changed. This prevents inadvertent adjustments to the installation setup parameters.
Refer to the Setup section. Begin by pressing the key, followed by pressing the
INSTALLATION SETUP soft key. Press the access code numbers using
the numeric key pad, then press the key. The readout is now ready for machine
parameter setting operations.
IMPORTANT
The access code is 8891
IMPORTANT
Supervisors may wish to remove this page from the Reference
Manual after initially setting up the readout system. Retain in a
safe place for future use.
To Next Page
Loading...