Anritsu MS2665C - Section 5 Basic Operation Procedure

SECTION 5 BASIC OPERATION PROCEDURE
5-1
SECTION 5
BASIC OPERATION PROCEDURE
TABLE OF CONTENTS
Signal Display
.....................................................................................................................................
5-3
Turn the power on
.......................................................................................................................
5-3
Execute automatic calibration
.....................................................................................................
5-4
Set the signal to the center of the screen
...................................................................................
5-4
Enlarge and display the signal
....................................................................................................
5-5
Marker Operation
................................................................................................................................
5-6
Check of the zone marker function
The "marker → CF" function check
"Measure" Function Check
..................................................................................................................
5-8
Screen Hard Copy
...............................................................................................................................
5-9
Initialization (Restore shipment state)
.................................................................................................
5-10