Anritsu MS2665C - Section 2 Preparations before Use

SECTION 2 PREPARATIONS BEFORE USE
2-1
SECTION 2
PREPARATIONS BEFORE USE
This section explains the preparations and safety procedures that should be performed before using the MS2665C/67C/68C
Spectrum Analyzer. The safety procedures are to prevent the risk of injury to the operator and damage to the equipment.
Insure that you understand the contents of the pre-operation preparations before using the MS2665C/67C/68C.
For connecting the GPIB cable and setting the GPIB address, see the Remote Control part of the separate Operation Manual
Vol.3.
TABLE OF CONTENTS
IInstallation Site and Environmental Conditions
..................................................................................
2-3
Locations to be avoided
..............................................................................................................
2-3
Fan clearance
.............................................................................................................................
2-3
Safety Measures
.................................................................................................................................
2-4
Power-on
.....................................................................................................................................
2-4
Input level to RF Input
.................................................................................................................
2-5
Connector of RF Input
.................................................................................................................
2-5
Installation
...........................................................................................................................................
2-6
Rack mounting
............................................................................................................................
2-6
Preparations before Power-on
............................................................................................................
2-7
Connecting the Power Cord
........................................................................................................
2-8
Replacing fuse
............................................................................................................................
2-9
Precaution for Handling Memory Card
................................................................................................
2-11