Anritsu MS2665C - Connecting the Power Cord

SECTION 2 PREPARATIONS BEFORE USE
2-8
Connecting the Power Cord
Check that the [Line] switch on the rear panel is turned off.
Insert the power plug into an outlet, and connect the other end to the power inlet on the rear panel. To ensure
that the instrument is earthed, always use the supplied 3-pin power cord, and insert the plug into an outlet with
an earth terminal.
WARNING
If the power cord is connected without the instrument earthed, there is a risk of receiving a
fatal electric shock. In addition, the peripheral devices connected to the instrument may be
damaged.
When connecting to the power supply, DO NOT connect to an outlet without an earth terminal.
Also, avoid using electrical equipment such as an extension cord or a transformer.
CAUTION
If an emergency arises causing the instrument to fail or malfunction, disconnect the instru-
ment from the power supply by either turning off the [Line] switch on the rear panel, or by
pulling out the power cord or the power inlet.
When installing the instrument, place the instrument so that an operator may easily operate
the [Line] switch.
If the instrument is mounted in a rack, a power switch for the rack or a circuit breaker may be
used for power disconnection.
It should be noted that, the [Power] switch on the front panel of the instrument is a standby
switch, and cannot be used to cut the main power.