AOR AR2700 - 9-6 Scanning a memory bank which is not selected in BANK LINK; 9-7 SCAN channel PASS - CH PASS (lockout), general outline; 9-8 Memory scan PASS while scanning; 9-9 Memory CHANNEL PASS & review using Memory Recall mode

AR2700 operating manual
43
The left of the “oF / on” legend and lower row of the LCD provide places for all
ten scan banks. To add more banks to the bank link list simply press the
appropriate identifying scan bank number using the numeric keypad, the
number legends will toggle On and Off... the legend “ - “ depicting Off
(unselected).
To accept the new list and setting press [ENT].
The next time the receiver enters SCAN MODE with bank link specified as On,
the legend “SCAN” “LINK” will be displayed and a group of scan banks will be
scanned together as one large group.
9-6 Scanning a memory bank which is not selected in BANK LINK
It is still possible to SCAN a single deselected bank by manually bypassing the
BANK LINK programming. To SCAN any deselected bank simply key the
desired identifying bank number through the keypad and press either the [UP]
or [DOWN] key.
Only the scan bank manually selected will be scanned.
9-7 SCAN channel PASS - CH PASS (lockout), general outline
Should the AR2700 stop on an active channel while scanning and for some
reason you do not wish to monitor it any longer, simply press the UP / DOWN
keys or rotate the [DIAL] to force the SCAN process to resume in the direction
selected.
However, should the receiver continually stop on the same channel you may
wish to PASS (lockout) the channel so that it will be skipped over when the
bank is next scanned.
Memory scan channels may be PASSED (locket out) either when the receiver
stops in scan mode (when they are active and the receiver has stopped
scanning) or by recalling them in memory recall mode.
9-8 Memory scan PASS while scanning
To PASS a channel when scanning, wait for the channel to become active then
press [2ndF] [8]. The legend “CH PASS” will be added above and to the left of
the LCD to indicate that the channel has been locked out and the scan process
will move on to the next channel. This process will happen so quickly that
you will not see the “CH PASS” legend being added. However, should
the memory channel subsequently be recalled using memory recall, the
“CH PASS” legend will be displayed to signify CHANNEL PASS.
9-9 Memory CHANNEL PASS & review using Memory Recall mode
Memory scan channels may be “tagged” for “PASS”, un-tagged or reviewed
using memory recall mode.