Applied Biosystems SimpliAmp Thermal Cycler User Manual

c. Touch Done to return to the Edit Method screen.
d. Use the buon in the top right corner of the screen to return to the
Advanced Options screen.
• Touch AutoDelta to apply the AutoDelta seing to a step.
a. Touch the icon to choose the steps you want to apply AutoDelta.
Figure 16 Advanced Options — AutoDelta
b. In the Edit AutoDelta screen, enter the information for seing up
AutoDelta.
a. Enter the Starting Cycle.
b. Enter the DELTA temperature and/or time. Use the '-' and '+' toggle
buon to set the DELTA values to be either negative or positive,
respectively.
c. Touch Remove AutoDelta to remove the AutoDelta seing.
Note: Remove AutoDelta is visible only if there is an existing
AutoDelta seing.
d. Touch Done when nished or Cancel to exit the screen.
Figure 17 Edit AutoDelta
c. Touch Done to return to the Edit Method screen.
Once you have edited a run method, you can save the method to the destination
folder by touching Save As in the Run Method preview screen or choose to start
a run without saving the run method.
Chapter 3
Create and run experiments on the instrument
Edit a run method
3
20 SimpliAmp
™
Thermal Cycler User Guide

Applied Biosystems SimpliAmp Thermal Cycler Specifications

General

Brand	Applied Biosystems
Model	SimpliAmp Thermal Cycler
Category	Bicycle Accessories
Language	English