11
Quality for Professionals
专业质量
Fig. :2
图：2
在控制模块右侧连接（30A）保险丝。
Store excess cable in the driver's cab to avoid trapping it.
将多余的电缆存放在驾驶室内避免绊住。
IMPORTANT NOTES
：
注意事项：
The 12 Volt power supply must NOT be connected to the cigarette lighter!
切勿将 12V 电源连接到点烟器！
After using the device, the controller should be disconnected (for safety reasons).
运行设备之后，（为了安全起见）应断开控制器。
ATTENTION: Failure to observe these instructions can result in damage to the control module!
注意
：未遵守上述指示可导致控制模块发生损坏！
TIP: If your tractor does not have a standard socket, it can be retrofitted with the Complete
Cable Kit for Power Sockets, Tractor Retrofit (Item no. 00410-2-022) (special accessory).
提示
：如果拖 拉机未 配有 标准插座，您可以加装供拖拉机改装电 源插座 使用的电缆套 件
（00410-2-022）（特殊配件）。
ATTENTION: If the battery is charged by a charger which is in the "Start" operating mode, this
may result in voltage peaks! These can damage the control module's ,electrical system if the
control module is also connected when charging the battery!
注意
：如电池充电时，充电器处于“启动”运行模式，可能导致产生峰值电压！如果在电池充电时，
也连接了控制模块，这些峰值电压会损坏控制模块的电气系统！
To Next Page
Loading...
Need help?
General