EasyManuals Logo

APV 5.2 User Manual

APV 5.2
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
43
Quality for Professionals
专业质量
4 Controller messages
4
控制器消息
4.1 Notes
4.1
注意
Display
显示器
Cause
原因
Solution
解决方案
Displayed if the internal control
voltage is below a minimum value.
如果内部制电压低最低值,
示该消息。
Return to factory.
退回工厂。
Displayed if the operating voltage is
too low.
如果工作电压过低,即显示该消息。
Minimise consumers;
尽可能减少耗电装置;
Check battery; Check cabling;
检查电池;检查电缆布线
Check generator;
检查发电机;
Operating voltage must be above
10V (Point 3.8)
工作电压必须高 10V(第 3.8 点)
Indicates that the operating voltage
is too high.
表明工作电压太高。
Check generator
检查发电机
This message is displayed if the
level sensor has not been covered
by seed for more than 30 seconds.
如果种子盖料位传器的时间
超过 30 秒,则显示该消息。
Refill seed. It is possible that the
sensor is incorrectly adjusted
(screw in further).
再加入种子。可能未对传感器进行
确调整(未进一步正确调整螺钉)

Table of Contents

Other manuals for APV 5.2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APV 5.2 and is the answer not in the manual?

APV 5.2 Specifications

General IconGeneral
BrandAPV
Model5.2
CategoryControl Unit
LanguageEnglish