60
Quality for Professionals
专业质量
5.8 Tractor linkage pull switch sensor (item no.: 00410-2-115)
5.8
拖拉机联动装置拉线开关传感器（项目编号：
00410-2-115
）
Fig.: 16
图：16
Connection:
连接：
12-pin connector on the control module
控制模块上的 12 插孔连接器
Calibration:
校准：
See under point 6.7
见第 6.7 点
Cable length:
电缆长度：
5m
5 米
Thanks to this sensor, the sowing shaft of the PS can automatically unlock and stop when the working
tool is raised or lowered.
安装该传感器之后，当工作工具上下来回运行时，PS 播种轴能够自动解锁和停止。
Installation
location:
安装位置：
Using a spring (for length compensation) and a chain, it is possible to connect
two points - which move relative to each other during machine lifting. The switch
is actuated by the change in length, thus switching off the sowing shaft. Similarly
to the tractor linkage sensor upper link, the pull switch can be mounted on the
three-point and tensioned with the chain, e.g. at the coupling device on the
To Next Page
Loading...
