70
Quality for Professionals
专业质量
At the battery, this is screwed right to the battery terminals, a standard 3-pin socket is mounted at the
other end.
电池须正确栓接到电池接线柱,标准 3 插孔插座安装在另一端。
6 Programming 5.2 (customer service)
6
程序设计
5.2
(客户服务)
To call up the programming menu, the following buttons (see figure) must be held pressed at the same
time until the customer service menu appears.
为调用程序设计菜单,必须同时按下以下按钮(见图示),直至出现客户服务菜单。
Fig.: 23
图:23
- Browse through programming
menu
- 浏览程序设计菜单
- Modify parameters
- 修改参数
- Ends and confirms the programming
- 关闭并确认程序设计
Note: Note: If a value has been changed in the programming menu and the programming
menu exited, the control box switches off automatically. Then, restart the control box in order
to adopt the changed settings.
注意:注意:
如果程序设计菜单中已经更改了数据并且退出了程序设计菜单,控制箱将自动关
闭。然后,重新启动控制箱,应用经更改后的设置。
If set to AUTO, the control box automatically detects which sensor is connected and sending
signals.