ARCHTTP PROXY SERVER INSTALLATION
60
(1). Insert the SATA RAID controller CD in the CD-ROM drive.
(2). Copy <CD-ROM>\PACKAGES\Mac\http directory to local (Ex:/
usr/local/sbin).
Or
(1). Download from the www.areca.com.tw or from the email
attachment.
2. You must have administrative level permissions to install SATA
RAID controller ArcHttp proxy server software. This procedure
assumes that the SATA RAID hardware and driver are installed and
operational in your system.
The following details are the installation procedure of the SATA
RAID controller for ArcHttp proxy server software.
(1).Run the Archttp proxy server by using the following command:
Usage: ./archttp32 (TCP_PORT) or ./archttp64 (TCP_PORT). It
depends on your OS version.
Parameters: TCP_PORT value= 1~65535 (If TCP_PORT assigned,
Archttp will start from this port. Otherwise, it will use the setting in
the archttpsrv.conf or default 81). This is the port address assigning
for the rst adapter.
Such as: archttp64 1553
(2). Archttp server console started, controller card detected then
ArcHttp proxy server screen appears.
Copyright (c) 2004 Areca, Inc. All Rights Reserved.
Areca HTTP proxy server V1.80.240 for Areca RAID controllers.
Controller(s) list
--------------------------------------------
Controller[1](PCI) : Listen to port[1553].
Cfg Assistant : Listen to port[1554].
Binding IP:[0.0.0.0]
Note: IP[0.0.0.0] stands for any ip bound to this host.
--------------------------------------------
##############################
Press CTRL-C to exit program!!
##############################
To Next Page
Loading...
