Ariston GENUS PREMIUM EVO 24

Training manual ALTEAS & GENUS ONE
Page. 27 of 88
4.5 “AIR PURGE” Function
This function can be activated by the installer by the parameter 2 71 or pressing of the mode button for
5 sec (continues till to the finish (about 6’) or pressing of the mode button ).
Lo scopo di tale funzione è quello di aiutare ad espellere l’aria dal circuito primario dopo un riempimento.
It’s aim is to help to purge the residual air inside the primary circuit after a filling cycle. At the activation the
following cycle is begun:
This cycle can be repeated several times, till the boiler and the heating system are completely purged from
air.
Using the manual air purge on the heat exchanger it is possible drain
the ait from it.
3 way valve in heating
Pump on 60 sec.
Pump off 30 sec.
3 way valve in sanitary
Pump on 60 sec.
Pump on 60 sec.
3 way valve in heating
Pump on 60 sec.
Pump off 30 sec.
Pump on 60 sec.