EasyManua.ls Logo

Arjo MAXI MOVE - Care and Maintenance; Battery Charging and Safety Practices

Arjo MAXI MOVE
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
Recharge the battery as follows:
1 When the handset display shows a low battery icon,
complete the lift/lower cycle and remove the battery
pack.
2. Insert the battery pack into the charger unit and push
it in firmly. The green LED should already be on,
showing that the charger is powered. The charging
connection will be made automatically.
3. The amber LED indicator will flash on and off as the
battery pack is being charged. When the battery pack
is fully charged, the amber LED will turn solid. The
battery pack is then ready for use. Discharged
batteries should take approximately eight hours to
fully recharge.
4. When the batteries are fully charged, remove the
pack from the charger, and insert it back into the
Maxi Move. An electrical connection is made
automatically.
5. Press the power button. The Maxi Move is ready for
use.
A good protocol to follow can include having fully
charged batteries ready for the start of every work shift.
For recycling and disposal of the battery packs, the rules
according to local regulations must be followed. If not,
they may explode, leak and cause personal injury. When
returning batteries, insulate their terminals with adhesive
tape, otherwise, the residual electricity in used batteries
may cause fire or explosions. The following diagram
shows the symbols for disposal and recycling (see Fig.
72).
Fig. 72
Battery and Battery Charger
Safety Practices
The charger is for indoor use only, and should be
used in a dry environment. Do not use it in a
bathroom.
Do not charge batteries in unventilated areas.
The battery charger must not be covered or exposed
to dust. The metal contacts must be kept clean.
The battery charger is for use only with Maxi Move
batteries that are supplied by ARJO.
The battery pack may stay connected to the charger
unit when it is fully charged without damage.
Do not short-circuit the battery pack.
Do not crush, puncture, open, dismantle or otherwise
mechanically interfere with the batteries.
The power socket must be easily accessible. If a
faulty condition occurs, switch off the power and
remove the plug from the wall socket.
Do not store battery packs at a temperature higher
than 40°C (140°F). Should the battery pack casing
crack and cause contents to come in contact with skin
or clothing, rinse immediately with water. If content
comes in contact with the eyes, rinse immediately
with plenty of water and seek medical attention.
The abbreviation “Pb” shown adjacent to the
recycling and trash bin symbols on the battery pack
label is the element symbol for lead. It indicates that
the battery contains lead, and therefore should not be
disposed of, but recycled.
WARNING: Hold the pack firmly to ensure that
it does not drop and become damaged or
cause personal injury.
WARNING: Do not place or store the battery
pack under direct sunlight or near a heat
source. Do not expose the batteries or the
battery charger to flames.
Care of your Maxi Move

Table of Contents

Other manuals for Arjo MAXI MOVE

Related product manuals