• You can Remove one Part in a Multi and turn the Preset into a Single Preset.
◦ When in the Preset display mode, hold Shift while pressing one of the
Part buttons.
◦ Turning the encoder to Remove Part 1 (or 2) will remove that part and
turn the Preset into a Single Preset.
4.2.2. Quickly Create a Multi
To keep Part 1 intact when a Single Preset is displayed, follow these steps:
• Hold Shift and press Part 2. Release Shift and press the Encoder to confirm
selection of Part 2.
• Use the Screen Encoder to select and load a Preset. You may also press a Preset
Type button and use the Screen Encoder to select Part 2. Press the encoder to
confirm.
If the Part 2 Preset has effects, they are not loaded. Instead, Part 2 is routed by default to
the Delay and Reverb (you can change this later).
4.2.3. Other Part Actions
With the current Part displayed, press Shift plus the relevant Part button to enter a brief
menu of utility functions for Parts: Like, Save, Move, Delete, Keyboard Settings, and Info.
4.2.3.1. Like/Unlike Preset
As in Analog Lab, you can “Like” Presets. In AstroLab, they become available in the
Liked
section of the Library.
If a Preset has been liked, the heart symbol in the center of the screen will be filled. If not,
the heart will be outlined.
4.2.3.2. Save Preset
This duplicates the Save button functions described in the previous chapter. You are given
the choice to save the preset with its current name or a new name.
4.2.3.3. Add to Playlist
Clicking here adds the current Preset to a Playlist.
4.2.3.4. Delete Preset
Deletes the current Preset; prompts for “Are You Sure?” confirmation.
Arturia - User Manual AstroLab - PRESET ARCHITECTURE AND EDITING 29
To Next Page
Loading...
