6.10.1. MultiFilter
This is like having a multi-mode synth filter in pedal form.
Control Description
Mode Chooses the filter type
Cutoff Sets cutoff or center frequency of filter
Q Increases or decreases the amount of emphasis at the corner frequency / frequencies
Slope Select the filter steepness (LP/HP/BP only)
Dry/Wet
6.10.2. Parametric EQ
This is a 3-band parametric EQ with adjustable bandwidth for the mid band (Peak) and
shelving curves for the high shelf (HS) and low shelf (LS) bands.
Control Description
Gain (x3) Boosts or cuts each band
Frequency (x3) Adjusts the frequency of each band
Q Adjusts the bandwidth of the mid band
Scale
Controls the gain of all EQ stages at the same time
6.10.3. Compressor
A compressor is generally used to maintain a consistent level of sound, though there are
many other ways to use one. For example, it can keep the attack transients of a sound from
overloading the input of the next effect. It can also help a sound which would normally
decay quickly not to fade away as quickly.
Control Description
Threshold Sets the level where compression will begin
Ratio The amount of compression to be applied once the threshold is reached
Attack Adjusts the speed with which the compression will be applied once the threshold is reached
Release Sets the release curve of the compressor
Output Gain Compensate for reduction in volume if compression lowers the output level
Make Up Enables automatic control of the output level
Dry/Wet Balances the input signal and the compressed signal
Arturia - User Manual AstroLab - EFFECTS 39
To Next Page
Loading...
