Astralpool ECO ELYO Series - Installation Precautions

6
❶ Installaon
1.1 I Selecng the locaon
1.1.1 Installaon precauons
• The appliance should be installed at a distance of at least 2 metres from the edge of the pool.
• Do not li the appliance by the body; use its base.
• The appliance can only be installed outdoors : provide free space around it (see § “1.1.2 Selecng the locaon”).
• Place the appliance on its an-vibraon pads (supplied with appliance) on a stable, solid and level surface.
• The surface must be able to bear the weight of the appliance (in parcular in the case of installaon on a roof, a
balcony or any other support).
• The appliance may be secured to the ground using the holes in the base of the appliance or with rails (not supplied).
: Front
: Rear
: An-vibraon pads
View of the appliance base from below for installing the an-vibraon pads
The appliance must not be installed:
• In a closed and unvenlated room,
• In a locaon where it would be subject to snow build-up,
• In a locaon where it might be ooded by the condensates produced by the appliance when operang.
• In a locaon subject to high winds,
• With the blowing towards a permanent or temporary obstacle (awning, brushwood, etc.) less than 2,5 metres away,
• On brackets,
• Within range of water or mud jets, sprays or run-o (take the eect of the wind into account),
• Near a heat source or ammable gas,
• Near high-frequency equipment,
Tip: to reduce noise produced by your heat pump
• Do not install it under or facing a window.
• Do not lt it towards your neighbours.
• Install the appliance in an open space (sound waves are reected on surfaces).
• Install an acousc screen around the heat pump, respecng the distances (see § “1.2 I Hydraulic
connecons”).
• Install 50cm of exible PVC pipe at the heat pump water inlet and outlet (to stop vibraons).