Astralpool ECO ELYO Series - User Functions and Timers; Maintenance, Troubleshooting, and Specifications; Winterising Procedures

15
2.3.3 Anfreeze protecon (if heang priority is acvated)
• For the anfreeze protecon to work, the heat pump must be powered and the ltraon pump
acvated. If the heang priority is acvated, the anfreeze protecon will work automacally.
When the heat pump is on stand-by, the system monitors the ambient temperature and the water temperature in
order to acvate the anfreeze programme if required. The anfreeze protecon is automacally acvated when the
air temperature or water temperature are less than 2°C and when the heat pump has been shut down for more than
120 minutes. When the anfreeze protecon is running, the appliance acvates its compressor and the ltraon pump
to reheat the water unl it exceeds 2°C .The heat pump automacally leaves the anfreeze mode when the ambient
temperature is higher than or equal to 2°C or when the heat pump is acvated by the user.
2.4 I User funcons
2.4.1 Locking/unlocking the keypad
• Press for 5 seconds to unlock the keypad. The keypad is automacally locked aer 60 seconds of inacvity.
2.4.2 Seng the me (clock)
• Unlock the keypad: the main menu is displayed.
• Press 5 seconds to enter the clock seng interface.
• Press - the hours are blinking. Press and to adjust the hours.
• Press - the minutes are blinking. Press and to adjust the minutes.
• Press to conrm and return to the main screen.
2.4.3 Seng the mer
• If two dierent mers are set up on the ltraon pump and on the heat pump, the mer on the
ltraon pump will be ignored.
• If a mer is set on the heat pump, it is recommended to acvate the “heang priority” to
ensure that the pool will be heated during this me slot (the heat pump only works when the
ltraon pump is also working).
Three mer programs can be set up on the heat pump.
• Unlock the keypad: the main menu is displayed.
• Press to enter Timer 1 funcons. Timer 1 is blinking.
• Press to enter Timer 1 ON hours. Press and to adjust the start hours.
• Press again to set the minutes. Press and to adjust the start minutes.
• Press again to set Timer 1 OFF hours and minutes as done in the previous steps.
• Press to conrm Timer 1 ON/OFF sengs.
• Press and to set Timer 2 ON/OFF sengs.
EN