ROG Striker II Extreme / Striker II NSE 4-41
Supervisor Password
User Password
To set a password:
1. Select an item then press <Enter>.
2. Type in a password using a combination of a maximum of eight (8)
alpha-numeric characters, then press <Enter>.
To clear the password:
appears:
PASSWORD DISABLED !!!
Press any key to continue...
A note about passwords
The Supervisor password is required to enter the BIOS Setup program
Forgot your password?
If you forget your password, you can clear it by erasing the CMOS Real Time
Clock (RTC) RAM. The RAM data containing the password information is
powered by the onboard button cell battery. If you need to erase the CMOS
RAM, refer to section “2.6 Jumper” for instructions.
Password Check
system. Select [Setup] to require the password before entering the BIOS Setup.
Select [System] to require the password before entering the system.
To Next Page
Loading...
