Chapter 2: Hardware Information
2-6
7. Reinstall the air duct. For more information, see the section
Air Duct
.
6. Twist each of the four screws with a screwdriver just enough to attach the heatsink to
the motherboard. When the four screws are attached, tighten them one by one in the
sequence 1, 2 then 3, 4 as shown on the heatsink to completely secure the heatsink.
• The heatsink screws are T30 models. A torque value of 12 inch-lbf is recommended.
• When uninstalling the heatsink ensure to loosen the four screws in the sequence 3, 4
then 1, 2 as shown on the heatsink.
1
2
3
4
To Next Page
Loading...
Need help?
General