AT&T CL83107 - Call Screening

Answering system
Call screening
Use this feature to choose whether incoming messages
can be heard over the speaker when they are being
recorded. If you turn call screening on, you hear the
incoming message. While monitoring an incoming
message, you can answer the call by pressing
PHONE/FLASH on the handset, or /SPEAKER on the
telephone base.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode,
press MENU/
SELECT to enter the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then
press
MENU/SELECT.
3. Press T
CID or SDIR to scroll to Ans sys setup, then
press
MENU/SELECT.
4. Press
MENU/SELECT to select Call screening.
5. Press T
CID or SDIR to choose On or Off.
6. Press
MENU/SELECT to save the setting. You hear a
confirmation tone.
Note: For more information on call screening, see page 123.
Answering system settings
Answer ON/OFF
>Ans sys setup
> Call screening
# of rings

CALL SCREENING
>On
Answer ON/OFF
>Ans sys setup
S

T
> Call screening
# of rings
S

T

CALL SCREENING
>On
S

T
113