AT&T CL83107 - Remote Access Code

Answering system
Answering system settings
Remote access code
To access your answering system remotely from any touch-
tone phone, you need to enter a two-digit number (00-99). By
default, the remote access code is 19.
To change the remote access code:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode,
press MENU/
SELECT to enter the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then
press
MENU/SELECT.
3. Press T
CID or SDIR to scroll to Ans sys setup, then
press
MENU/SELECT.
4. Press T
CID or SDIR to scroll to Remote code, then press
MENU/SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE on the handset or X/DELETE on the
telephone base to backspace and delete a digit.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.

REMOTE CODE
19

Answer ON/OFF
>Ans sys setup

Play messages
>Answering sys

Play messages
>Answering sys
S

T

Voice guide
>Ans sys setup
S

T

REMOTE CODE
19
115