AT&T CL83107 - Call Intercept; Base Ringer; Message Alert Tone

Answering system
About the answering system
Call intercept
While screening a call, you can stop recording and speak to the caller by pressing
PHONE/FLASH on the handset or /SPEAKER on the telephone base.
Base ringer
Press T/VOLUME/S on the telephone base to adjust the ringer volume
when the telephone is not in use.
You hear a sample of the ringer while adjusting the volume. The telephone
base shows «¼Áº¸ÅÂæ
when you set the volume to 0.
¸ÀÃÂŴż¿ÌÇÈÅÁ¼ÁºÂæÇ»¸À¸ÆÆ´º¸´¿¸ÅÇÇÂÁ¸
If the message alert tone is turned on, the telephone base beeps every
ten seconds when there are new messages. Pressing any telephone base key
(except
/FIND HS) temporarily silences the message alert tone.
If you press X/DELETEÊ»¸Á¼Á¼·¿¸À·¸ÇÂǸÀÃÂŴż¿ÌÇÈÅÁÂæÇ»¸
message alert tone, there is a voice prompt directing you to press X/DELETE
´º´¼ÁÇÂ·¸¿¸Ç¸´¿¿¿·À¸ÆÆ´º¸Æ»¸À¸ÆÆ´º¸´¿¸ÅÇÇÂÁ¸¼ÆǸÀÃÂŴż¿ÌÂæ
Only press X/DELETE a second time if you wish to erase all old messages in
your answering system.
The message alert tone resumes when you receive another message.
121