AT&T CL83107 - Message Playback

Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every ten seconds. Unless you change it,
Ç»¸À¸ÆÆ´º¸´¿¸ÅÇÇÂÁ¸¼ÆƸÇÇÂÂæ
There is no audible alert at the handset.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press
MENU/
SELECT to enter the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then
press
MENU/SELECT.
3. Press T
CID or SDIR to scroll to Ans sys setup, then
press
MENU/SELECT.
4. Press T
CID or SDIR to scroll to Msg alert tone, then
press
MENU/SELECT.
5. Press T
CID or SDIR to choose On or Off.
6. Press
MENU/SELECT to save the setting. You hear a
confirmation tone.
Notes:
f The message alert tone beeps only if all the following conditions are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
f To temporarily turn off the message alert tone, see page 124.
MSG ALERT TONE
>On
Remote code
> Msg alert tone
MSG ALERT TONE
>On
S

T
Remote code
> Msg alert tone
S

T
116