AT&T CL83107 - Screen Messages

Appendix
Screen display messages
Screen messages
No answer. Try
again
The device(s) you are trying to transfer a call to is out of range,
Âæ»Â¾ÂÅ»´ÆÁÂÃÂʸÅ
No battery
The handset in the charger has no battery installed.
No caller info
The caller information is unavailable.
Not enough batt
to power base
The handset does not have enough charge to power up the
telephone base.
No line
There is no telephone line connection.
Number already
saved
The telephone number you have entered is already in the
directory.
Not available
at this time
Someone else is already using the directory or caller ID log.
No Incoming PTT
»¸¼Á¶ÂÀ¼Áº©¹ÈÁ¶Ç¼ÂÁ¼ÆÇÈÅÁ¸·Âæ»¸»´Á·Æ¸Çʼ¿¿ÁÂÇ
receive PTT calls.
Out of range OR
No pwr at base
The telephone base has lost power, or the handset is out
of range.
** Paging **
The cordless handset is paged by the telephone base.
Paging all
handsets
The telephone base is paging all cordless handsets.
Phone
The handset is on a call.
Place in charger
The battery is very low. The handset should be charged.
Powering base...
Don’t pick up
The handset on the telephone base is powering up the
telephone base in the event of power outage.
Put HS on base
to power base
There is no handset placed in the telephone base during power
outage.
Pwr outage mode
Battery backup mode is activated.
Quiet mode on
QUIET mode is on.
Quiet mode is off
ª®¢À·¸¼ÆÇÈÅÁ¸·Âæ
Rec mem full
The system recording time is full.
Rec mem low
The system recording time is low.
Recording message
The telephone is recording a message.
Registering...
Please wait
The handset is registering to the telephone base.
138