AT&T CL83107 - Answering System; Answering System Settings; Announcement

Answering system settings
Use the answering system menu of a system handset or
the telephone base to set up the announcement message,
ÇÈÅÁÂÁÂÅÂæÇ»¸´ÁÆʸżÁºÆÌÆǸÀÂÅÀ¸ÆÆ´º¸´¿¸ÅÇÇÂÁ¸
activate call screening, or change the number of rings,
remote access code or message recording time. If you turn
ÂæÇ»¸´ÁÆʸżÁºÆÌÆǸÀ´Á·ÌÂÈ¶»´Áº¸´ÁÌƸÇǼÁº¼Áthe answering system
setup menu, the answering machine automatically turns on again.
1. When the device is in idle mode, press MENU/
SELECT to enter the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then press MENU/SELECT.
Announcement
Your outgoing announcement plays when calls are answered by the
answering system.
The telephone has a default outgoing announcement, “Hello. Please leave a
À¸ÆÆ´º¸´ì¸ÅÇ»¸ÇÂÁ¸” You can use this announcement, or record your own.
You can record an announcement up to 90 seconds. The system does not
record any announcement shorter than two seconds.
To play your current outgoing announcement:
Using a cordless handset:
1. When the handset is in idle mode, press MENU/
SELECT to
enter the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press
MENU/SELECT again to select Announcement.
4. Press T
CID or SDIR to scroll to Play annc, then press
MENU/SELECT.
Using the telephone base:
1. When the telephone base is in idle mode, press
MENU/
SELECT to enter the main menu.
2. Press T
CID or SDIR to scroll to Answering sys, then
press
MENU/SELECT.
3. Press
MENU/SELECT again to select Announcement.
4. Press T
CID or SDIR to scroll to Play annc, then press
MENU/SELECT.

Play messages
>Answering sys
> Announcement
Delete all old

Record annc
>Play annc

Record annc
>Play annc
S

T

> Announcement
Delete all old
S

T
Answering system
108