AT&T CL83107 - Battery Installation and Charging

Getting started
11
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery, the
screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery. For
best performance, keep the handset in the telephone base or charger when
ÁÂÇ¼ÁÈƸ»¸µ´ÇǸÅÌ¼Æ¹È¿¿Ì¶»´Åº¸·´ì¸ÅǸÁ»ÂÈÅÆ¹¶ÂÁǼÁÈÂÈÆ¶»´Åº¼Áº
See the table on page 161 for battery operating times.
If the screen shows Place in charger and ë´Æ»¸ÆÌÂÈÁ¸¸·ÇÂ¶»´Åº¸Ç»¸
handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table
summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger
and
ë´Æ»¼Áº
Battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery´Á·ë´Æ»¼Áº
Battery has enough charge
to be used for a short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base or
charger when not in use.
Step 1
Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label THIS SIDE UP
facing up, as indicated.
Note: If you are on a phone call in low battery mode, you hear four short beeps every minute.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles
:
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WA
RNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1349
THIS SIDE UP